Cutting Smooth Curves in Facial Tissue: Does Easier Turning Mean a Smoother Edge?

Cutting Smooth Curves in Facial Tissue: Does Easier Turning Mean a Smoother Edge?

LeGrand Editorial Team

THE QUESTION

When cutting wave-like curves in 1-ply and 3-ply facial tissue, how easily do two used pairs of scissors change direction, and how continuous are the finished cut edges?

THE SHORT ANSWER

In 12 wave-cutting attempts on 1-ply and 3-ply facial tissue, the used LeGrand 9-inch dressmaker scissors left comparatively smooth, continuous curves in the photographed sections under both conditions, although tissue clung to the blades near the end of the 3-ply cuts.

The used rainbow-colored comparison scissors felt easy to turn in 3-ply tissue, yet a narrow pointed projection appeared in an inspected edge. In 1-ply tissue, they were harder to steer, and the photographed edges showed more abrupt, angular transitions.

Cutting Smooth Curves in Facial Tissue: Does Easier Turning Mean a Smoother Edge?

TEST SETUP

MATERIAL TESTED

Household 3-ply facial tissue, tested in two conditions:

- 1-ply — a single layer separated from the tissue.
- 3-ply — all three layers kept together.

Up&Up Ultra Soft 3-ply facial tissue used as the cutting test materialThe same tissue product was used in both conditions.

TOOLS TESTED

Japanese Dressmaker Scissors for Fabric Cutting – High-Carbon Stainless Steel 9" (used)

Rainbow-colored comparison scissors (used; manufacturer, model, and previous use history unknown)

LeGrand fabric scissors and rainbow-colored comparison scissors used in the cutting tests

WHAT WE TESTED

We compared how two pairs of scissors handled wave-like cutting paths requiring repeated changes in direction.

The main focus was the continuity of the finished cut edges. We also recorded how easily each pair could be redirected and whether the tissue followed or clung to the blades during cutting.

HOW WE TESTED

Each pair of scissors was used to make three wave-like cuts in each tissue condition.

A total of 12 cutting attempts were completed:

- LeGrand scissors: three cuts in 1-ply and three in 3-ply tissue.
- Rainbow-colored scissors: three cuts in 1-ply and three in 3-ply tissue.

One operator attempted to create smooth, continuous curves while repeatedly changing cutting direction.

No standardized cutting template was used. Curve dimensions, cutting speed, cutting force, and tissue support were not instrumentally measured or standardized.

EVIDENCE

The overview photographs show the three cut tissue sections for each pair of scissors under each condition. Close-up photographs show selected portions of the resulting cut edges.

1-PLY TISSUE

LEGRAND 9-INCH DRESSMAKER SCISSORS

LeGrand scissors beside pieces of 1-ply facial tissue with curved cut edges.

Three wave-like cuts made in 1-ply facial tissue with the LeGrand scissors.

Close-up of 1-ply facial tissue cut with LeGrand scissors, showing several curved edges.

A closer view of the resulting curved cut edges.

Detail of a curved cut in 1-ply facial tissue made with LeGrand scissors.

The inspected edge shows a comparatively smooth transition through the curve, although the contour is not perfectly uniform.

RAINBOW-COLORED COMPARISON SCISSORS

Rainbow-colored scissors beside pieces of 1-ply facial tissue with curved cut edges.

Three wave-like cuts made in 1-ply facial tissue with the rainbow-colored scissors.

Close-up of 1-ply facial tissue cut with rainbow-colored scissors, showing a bend between the separated edges.

The inspected cut edge shows a locally abrupt change in direction.

Detail of a bend in a 1-ply facial tissue edge cut with rainbow-colored scissors.

A closer view shows a pointed, angular transition rather than a continuously rounded curve.

3-PLY TISSUE

LEGRAND 9-INCH DRESSMAKER SCISSORS

LeGrand scissors beside pieces of 3-ply facial tissue with curved cut edges.

Three wave-like cuts made in 3-ply facial tissue with the LeGrand scissors.

Close-up of 3-ply facial tissue cut with LeGrand scissors, showing an S-shaped gap between the cut edges.

A closer view of the resulting curved cut edges.

Close-up of a broad curve cut into 3-ply facial tissue with LeGrand scissors.

The inspected curved edge changes direction relatively continuously, without an obvious narrow pointed projection.

RAINBOW-COLORED COMPARISON SCISSORS

Rainbow-colored scissors beside pieces of 3-ply facial tissue with curved cut edges.

Three wave-like cuts made in 3-ply facial tissue with the rainbow-colored scissors.

Close-up of curved cut edges in 3-ply facial tissue cut with rainbow-colored scissors.

The inspected sections show some less continuous directional transitions along the cut edges.

Detail of a curved cut in 3-ply facial tissue made with rainbow-colored scissors.

One inspected section shows a narrow, pointed projection interrupting the surrounding curved contour.

← Older Post Newer Post →

WHAT WE NOTICED

With 1-ply tissue, both pairs of scissors experienced tissue following or clinging to the blades from an early stage of cutting.

The LeGrand scissors were more difficult to guide through curves than in the 3-ply condition, but they remained comparatively manageable.

The rainbow-colored scissors were noticeably harder to redirect. The operator attempted to form smooth curves, but the cutting action did not readily follow the intended path.

In 3-ply tissue, the LeGrand scissors initially felt relatively smooth when changing direction. Toward the end of the cut, however, loose tissue increasingly followed or clung to the blades, making the cutting action feel harder.

The rainbow-colored scissors felt relatively easy to redirect in the same condition. The operator felt that the scissors were turning smoothly while attempting to form continuous curves.

Tissue following the blades near the end of the 3-ply cuts was less pronounced with the rainbow-colored scissors than with LeGrand.

No quantitative difference in the severity of tissue clinging between the two scissors was established in the 1-ply condition.

WHAT THIS TEST SUGGESTS

In the 3-ply condition, the rainbow-colored scissors felt relatively easy to turn, but the finished cut included an unintended pointed projection. The LeGrand scissors felt harder to use near the end of the cut, yet the inspected edge remained comparatively smooth.

These results suggest that the ease of changing cutting direction does not necessarily correspond to the continuity of the finished curved edge.

Tissue followed or clung to the blades early in both 1-ply cutting conditions, alongside greater difficulty in controlling the curves.

However, the causes of tissue clinging and the observed contour irregularities were not isolated. Material support, cutting movement, and blade contact may have contributed, but their individual effects were not established.

LIMITS OF THIS TEST

This test used one household facial tissue product in 1-ply and 3-ply conditions, with three cutting attempts per scissor in each condition.

Only one used pair of each scissor type and one operator were involved. The condition, adjustment, and previous use of the scissors were not controlled.

The cutting paths, speed, force, and tissue support were not instrumentally standardized or measured.

The photographs provide qualitative observations of selected cut edges, not numerical measurements of cutting accuracy. No mechanical cause of the observed differences was established.

The results apply to the tested scissors and tissue conditions and should not be generalized to other scissors, materials, or cutting conditions.